Threadless Labret Post

SKU: THLS-LAB2014-TR

20GA / 0.8mm - 2.5mm Base

18GA / 1mm - 2.5mm Base

16GA / 1.2mm - 3mm Base / 4mm Base

Manufactured out of Implant Grade Titanium (Ti-6AL-4V-ELI ASTM F136)

Threadless Jewelry Method:

Threadless jewelry is tensioned by using the end of the attachment and bending it within the bar to hold into place. To create the tension insert the pin on the end of the attachment slightly into the bar and bend slightly. Once inserted into the bar the bend in the pin should create the tension needed to hold into place. Direction below:

  1. Insert the pin on the end of the attachment 1/4 - 1/3 into the bar. (Labret, barbell etc.)
  2. Slightly bend the insertion pin within the bar.
  3. Push the end into the shaft and test the fit.

Insuring the fit: Insure the attachment is held in place and is tight. Adjust as necessary, if the pin does not hold tight enough redo the steps & create more tension.

Item Thickness Base Size Length
THLS-LAB2014-TR
0.8mm - 20GA
2.5mm
6mm - 1/4"
THLS-LAB20516-TR
0.8mm - 20GA
2.5mm
8mm - 5/16”
THLS-LAB1814-TR
1.0mm - 18GA
2.5mm
6mm - 1/4"
THLS-LAB18516-TR
1.0mm - 18GA
2.5mm
8mm - 5/16”
THLS-LAB18716-TR
1.0mm - 18GA
2.5mm
10mm - 3/8”
THLS-LAB16516-3-TR
1.2mm - 16GA
3mm
8mm - 5/16”
THLS-LAB16716-3-TR
1.2mm - 16GA
3mm
10mm - 3/8”
THLS-LAB1614-TR
1.2mm - 16GA
4mm
6mm - 1/4"
THLS-LAB16516-TR
1.2mm - 16GA
4mm
8mm - 5/16”
THLS-LAB16716-TR
1.2mm - 16GA
4mm
10mm - 3/8”

You may also like

Recently viewed